T+A PA 3100 HV Integrated Amplifier

19000,00 

The T+A PA-3100 HV is a further development of the PA-3000 HV and is identical in most modules. The immediately visible difference is two VU meters in the front, which display the output power per channel logarithmically in watts at 4 ohms. In addition, a new concept for the analogue converter part and the voltage supply was developed similar to the A-3000 HV, which allows the PS-3000 HV to be connected and the stability and performance of the entire voltage supply to be increased again.

Описание

Overview

On request, the T+A PA 3000 HV and the T+A PA 3100 HV can also be equipped with high-end phono preamplifier modules, which have different circuit stopologies for MM or MC systems. It is also possible to install the analogue signal processor module from the T+A P 3000 HV for channel-separated sound control and loudness functions. The all-metal infrared remote control F3001 is supplied.

Technology

As in the T+A P 3000 HV, the circuit topology of the amplifiers is based on a cascode differential amplifier with hand-selected audio J-FET transistors and completely discretely constructed stages without an operational amplifier. This circuit concept and the quality of the components means that virtually no over-all-counter-coupling is necessary. Thanks to its high operating voltage, the HV technology also allows extremely high linearity as well as an extremely high dynamic range. Signals up to 60 Vpp can be processed undisturbed.

In the T+A HV series, switching and switching functions in the signal range of gas-tight encapsulated gold contact relays are adopted which, even after many years of operation, do not have any contact problems due to corrosion, dust, etc. and no ageing.

In the preamplifier, bi-stable relays are used in which no permanent coil current flows anymore and thus also no inductive impairment of the audio signals can take place. Due to the integration of the relays directly into the circuit, the signal paths are optimally short and there are no cable paths, such as conventional volume potentiometers. The volume control is also built with discrete precision resistors and gold contact relays, so there is absolutely accurate channel balance, no noise and no distortion.

The entire control electronics are deeply recessed and shielded in the 40 mm thick and fully milled front panel, on the front of which is the luminous and dimmable display (VFD) made of glass with wear-free sensor buttons.

 

SPECIFICATIONS
Pre-amplifier stage
Frequency response + 0 / – 3 dB: 0,5 Hz –300 kHz
Signal / noise ratio: 105 / 110 dB
Total harmonic distortion: < 0,001%
Intermodulation: < 0,001 %
Channel separation: > 90 dB
Nominal input sensitivity High level (RCA): 7 x 250 mVeff ... 6 Veff / 20 kOhms
Nominal input sensitivity Balanced (XLR): 4 x 500 mVeff ... 12 Veff / 5 kOhms
Outputs
Headphones: 50 Ohms
1 x Recorder: 250 mVeff / 100 Ohms
PRE out RCA: nom 1 Veff, max 9,5 Veff / 50 Ohms
PRE out XLR: nom 1,45 Veff, max 19,6 Veff / 50 Ohms
Output stage
RMS output per channel into 8 Ohms: 300 Watts
RMS output per channel into 4 Ohms: 500 Watts
Peak output into 8 Ohms: 380 Watts
Peak output into 4 Ohms: 700 Watts
Power bandwith: 1 Hz – 150 kHz
Frequency response + 0 / – 3 dB: 0,5 Hz – 180 kHz
Slew rate: 60 V/µs
Damping factor: > 65
Signal / noise ratio: > 115 dB
Total harmonic distortion: < 0,03 %
Reservoir capacity: 120000 µF
Mains / Accessories / Dimensions
Mains: 110 V/60 Hz or 220/240 V/50 Hz
Standby: < 0,5 W
Remote control: F 3001
Features: Trigger input +5 ... 20V for external switching-on Input 4 can be configured in surround mode (Surround pass-through)
connectivity for additional PS 3000 HV
LAN connector for home-automation systems
Dimensions (H x W x D): 17 x 46 x 46 cm
Weight: 38 kg
Finishes: Case: silver laquer 47 or titanium laquer 64
Heat sink: black 42
About T+A

T+A Эстония (Theory + Application) — немецкий аудиобренд, известный референсной инженерией, строгим индустриальным дизайном и бескомпромиссным подходом к звуку. T+A строит целые системы — от интегральных усилителей и мощников до ЦАПов, сетевых плееров и акустики — с акцентом на низкий шум, точность и долговечность.

Hi-Fi Market — официальный дилер T+A в Эстонии. Мы поставляем оригинальные компоненты с гарантией производителя и локальной поддержкой. Помогаем выбрать правильное направление T+A под вашу комнату и привычки прослушивания — будь то «система в одном бренде» или связка T+A электроники с тщательно подобранной акустикой и источниками.

Приходите в наш шоурум в Табасалу (рядом с Таллином), чтобы послушать выбранные компоненты T+A и спокойно обсудить практические нюансы подбора и настройки до покупки.

Постройте стереосистему с T+A

T+A особенно хорошо раскрывается, когда вы мыслите системой: начните с интегрального усилителя (или связки предусилитель + усилитель мощности), добавьте при необходимости сетевой плеер и ЦАП, а затем подберите стереоакустику под размер комнаты и дистанцию прослушивания.

Посмотрите совместимые категории для сбалансированной системы на T+A:

Если нужен быстрый и адекватный шорт-лист, напишите нам — предложим сочетания под вашу комнату, бюджет и понятный upgrade-план.

Получение и доставка

БЕСПЛАТНАЯ ДОСТАВКА ПО ЭСТОНИИ (Для заказов на сумму более 100 €)

Внутригосударственные посылки доходят до получателя в течение 3-5 рабочих дней с момента заключения договора купли-продажи. Договор вступает в силу при поступлении оплаты на счет продавца.

При желании, можете также забрать ваш заказ по адресу Kallaste 7, Tabasalu.

ОТПРАВЛЯЕМ ТОВАРЫ ТОЛЬКО В ЕВРОПЕЙСКИЕ СТРАНЫ!

В кассе просим заполнить все обязательные поля. *Для стран ЕС: на основании этих данных мы с вами свяжемся для уточнения стоимости доставки. Просим производить оплату после подтверждения стоимости доставки.

ВЛАДЕЛЕЦ ИНТЕРНЕТ-МАГАЗИНА

Владельцем магазина hifimarket.ee является фирма Audio Sommelier OÜ (регистрационный номер 16891515), адрес Kallaste, 7, Tabasalu Keskus, ЭСТОНИЯ 76901